On week 6, we started to make our level design prototype officially by using the materials prepared in the first picture here. Firstly I cut out the level design and sticked them together, then sticked the chopsticks at the side of the paper. After rolling the level design, we cut out four little squares using cardboard and punch the holes a little bit upper than the middle of the squares and we put joint them with the chopsticks, then we can stick the whole thing onto the card. Next, we drew use the bottle caps to draw two bigger ones and one smaller one on the cardboard, then cut them out and stick them like sandwiches together to make the controller of the character. Then cut another two squares and stick them together with a tooth picks in the middle, to make another handle on the top, and lastly use the string to connect both handles on the top and at the bottom, and stick the character on the string.
The process of making this prototype was so fun and unexpectedly excited. I would rate the difficulty of making this prototype 3.5/5, It is not hard to conduct the thing out but not easy to make it look nice and work smoothly.
Sharon's daily 